Sunglo Heater A242

Sunglo Heater A242

Sunglo Heater A242 is ideal for the patio requiring flexibility. These heaters have a free standing base for portability. Optional hose with quick connect coupling allows the heater to be quickly set up and operated.

The Sunglo™ model A242 free-standing heater is ideal for open patio designs. This model offers the flexibility to move or remove the heaters as needed. Optional tie-down kit is available to secure heaters to patio deck as required. When used with optional hose kit make sure that hose pathway does not present a trip hazard. Heat coverage varies depending on the wind exposure on patio. The average spacing between these heaters is 12 feet apart.

This heater utilizes a manually operated control system requiring no electrical power. The pilot/safety system provides both convenience and safety.

This heater offers a large deep disk aluminum reflector for maximum comfort, a primary aerated burner for minimal noise, and 100% safety shutoff.
The post is available in a variety of colors including black, green and bronze powder coat finishes or 304 stainless steel.

Sunglo Heater A242 Features:

  • 50,000 Btu/hr
  • Portable Base
  • CSA Design certified
  • 100% Safety Shutoff
  • Battery Operated
    Spark Ignition

 

Important Links:

– Sunglo Heater A242 Technical Sheet

– Sunglo Heater Instructions – 2020

– 60083 Floor Clamp Kit

 

The Sunglo™ model A242 free-standing heater is ideal for open patio designs. This model offers the flexibility to move or remove the heaters as needed. Optional tie-down kit is available to secure heaters to patio deck as required. When used with optional hose kit make sure that hose pathway does not present a trip hazard. Heat coverage varies depending on the wind exposure on patio. The average spacing between these heaters is 12 feet apart.

This heater utilizes a manually operated control system requiring no electrical power. The pilot/safety system provides both convenience and safety.

This heater offers a large deep disk aluminum reflector for maximum comfort, a primary aerated burner for minimal noise, and 100% safety shutoff.
The post is available in a variety of colors including black, green and bronze powder coat finishes or 304 stainless steel.

 

 

 

Heater Installation
Sunglo Heaters are intended to be installed by qualified personnel specifically trained and experienced in the installation of this type of heater and related system components. Some states or provinces require installation and service personnel to be licensed. If you state or province is such, be sure your contractor bears the appropriate license. Persons not qualified shall not attempt to install or repair this heater.
For Outdoor Use Only
Sunglo heaters are designed for outside use only. They are not for use in residential dwelling or other confined areas. Semi-enclosed patio are permissible provided they have adequate permanent openings around the patio periphery and meet the requirements for outdoors as defined in the installation instructions.
Clearance from Combustible Materials
Sunglo heaters all require a minimum distance from walls and ceilings. This is an important consideration before you purchase.  Refer to instructions for details
Clearance around the heater must be maintained.

 

Multiple heaters will provide overlapping coverage

Ventilation
Sunpak Heaters require adequate combustion air and ventilation to operate safely and efficiently. This requires openings above and below the level of the heater. Refer to the heater instructions for more detail.
Gas Pressure
Sunglo Heaters require a minimum inlet pressure of 6″ water column for natural gas and 11″ water column for propane gas. Gas pressure should never exceed 1/2 PSI or 14″ water column. For gas pressures exceeding 1/2 PSI a high-pressure regulator is required before the gas enters the heater.
Pipe Sizing
The inlet pipe size to the heater is 1/2 inch.  Larger pipe sizes maybe required depending on the distance from the gas meter and the total load capacity required for other gas appliances on the gas line.  Details regarding pipe sizing can be found in the Uniform Plumbing Code.
Agency Certification
Sunglo heaters are design certified by the CSA under the ANSI Z83.19 standard
Heater Gas Conversion
The factory does not support converting heaters to different gases. Each heater has been setup and tested for a specific gas type.  Please make sure you select the correct gas type, Natural or Propane gas, before making your purchase.